download native instruments maschine mk3 controller not working

The HAL plug-in folder contains drivers which are not supported.The MASCHINE software is not up to date.Click the possible causes one by one to be redirected to the corresponding troubleshooting steps below: Use Knob 1 under Interface to select Internal.This behavior can be caused by different factors.Use Buttons 5 / 6 to enter the Audio page.Start your MASCHINE+ and press the SETTINGS button.When using the internal MASCHINE+ audio interface, the headphone audio is output from the MASCHINE+ PHONES connector.įollow these steps to ensure that the right audio interface is selected. If using the stand-alone MASCHINE+ with an external USB audio interface, the headphone audio is output from the USB device's headphone connector. Check the MASCHINE+ (Stand-Alone) Audio Interface Please also check the documentation for your DAW if needed. Note: If using MASCHINE as a plug-in, check the audio and MIDI setup in your DAW preferences. This applies to MASCHINE and all other Native Instruments software. See this video to learn more about audio and MIDI setup. Try connecting the headphones to another device to make sure they're working as expected.Ĭheck MASCHINE Software Audio and MIDI SettingsĬheck to make sure the MASCHINE audio interface is set up properly.Make sure the headphone cable is fully inserted into the PHONES connector on the device.Further Troubleshooting Check the Headphones If there's still no sound from MASCHINE through your headphones, please see the next chapters for more troubleshooting steps. Press SETTINGS again and make sure the PHONES VOLUME knob is turned up.Use Knob 6 under Outputs Main to select + Phones.Use Buttons 5 / 6 to enter the Hardware page.Power on the controller and press SETTINGS.Launch the MASCHINE software and connect the device.MASCHINE MK3 / MASCHINE+ (Controller Mode) Device Settings Close the MASCHINE Preferences and make sure the PHONES VOLUME knob is turned up.On the Hardware page, tick the box next to Audio Outputs Route Main to Headphones.

Open the MASCHINE menu and go to File > Preferences.There's no sound from the MASCHINE MK3 or MASCHINE+ PHONES connector.įollow these steps either in the MASCHINE software preferences or device settings of your controller.

Download native instruments maschine mk3 controller not working